You are not logged in. Login Now
 0-24   6-30   31-55        
 
Author Message
25 new of 55 responses total.
mary
response 31 of 55: Mark Unseen   Oct 29 17:34 UTC 2002

I've been looking for quite some time now for a wok to replace
the cheap one we gots about 10 years ago, which we've worn out.
But buying any pan for a ceramic cooktop is tricky.  They must
have very flat bottoms that are no smaller than the diameter
of the heating element.  This is the only thing I don't like
about my cooktop, so I just deal with it.

So, back to the wok.  Today I went to Williams-Sonoma and
looked at what they had.  Again, two of the three they carry
wouldn't have worked.  But they had this iron one that's very
heavy, the bottom is a perfect (flat) fit, and the say it's
not a high-maintenance finish.  There is something not quite
non-stick that seals the iron but can take getting extremely
hot.  There weren't any instructions as to the care and
feeding of the surface so I'll see how it goes.

Tonight is Pad Thai.  Cross your fingers.  At least
Sonoma will take it back if I don't like it.  A hassle
but nice, nonetheless.
i
response 32 of 55: Mark Unseen   Oct 30 03:48 UTC 2002

!!!!!!!!

My understanding is that cast iron & smoothtop ranges mix about as well
as sodium & water - without superhuman care and attentiveness, you WILL
damage the range surface with the very hard & heavy iron.
mary
response 33 of 55: Mark Unseen   Oct 30 11:47 UTC 2002

It worked well last night, getting very hot and staying hot even when lots
of veggies and noodles were added at the same time. Cleanup was easy, just
a little soap and water and a light wipe.  And I found I actually liked
the fact it was heavy as I didn't need to keep one hand on a handle to
stabilize pan.  I could toss with both hands.  But I sure don't want to
harm my cooktop. 

Would you be worried about the weight or scratching the glass? 
I could always go back to my old pan and give this one to our
son.  He cooks everything he eats in a wok and his must be
on last legs too.
i
response 34 of 55: Mark Unseen   Oct 31 03:44 UTC 2002

I believe that the problem is mostly setting cast iron down on the
smoothtop - misjudge by 1/4" when quickly setting it down, and the
force of very heavy & hard iron meeting very inflexible & unyielding
top is too likely to crack the top.

I wonder if something like a thin copper disk could be used to
shield the top but not interfere with heat transfer too badly.
mary
response 35 of 55: Mark Unseen   Nov 1 06:23 UTC 2002

I hadn't considered the weight aspect as I find I don't even
think of the cooktop as ceramic.  I treat it with the same
respect as my countertops, meaning, almost none.

I'll see how it goes but buying an iron wok may not have
been the best choice, even a coated one.  I brought up woks
today at work and most of my Asian friends who do a whole 
lot of stir-fry meals use non-stick electric woks.
keesan
response 36 of 55: Mark Unseen   Nov 3 03:20 UTC 2002

I have a stainless steel electric wok and a stainless steel non-electric wok.
I generally just use a plain stainless steel frying pan instead of dragging
out the wok.
i
response 37 of 55: Mark Unseen   Nov 4 00:40 UTC 2002

It's possible that my knowledge of cast iron & smooth cooktops is dated...
did the new stove come with a meaningful manual, mary?
jmsaul
response 38 of 55: Mark Unseen   Nov 10 21:29 UTC 2002

I'm not sure how you use a wok up.  We've got a well-seasoned one from my
parents that they had before I was born.
slynne
response 39 of 55: Mark Unseen   Nov 10 21:43 UTC 2002

And they probably bought a nice new one, huh? Looks like your the 
sucker with an old wok, joe. nya nya ;)
slynne
response 40 of 55: Mark Unseen   Nov 10 21:43 UTC 2002

er you're
glenda
response 41 of 55: Mark Unseen   Nov 10 22:50 UTC 2002

My wok is almost 30 years old and gets heavy use.  It even survived being in
the oven full of tupperware when STeve turned the oven on without looking
inside first.  He had to take the propane torch to it to burn all the plastic
off and then it had to be reseasoned.
jmsaul
response 42 of 55: Mark Unseen   Nov 10 23:09 UTC 2002

Re #39:  Nah, they use an electric one.  ;-)  We've got a gas stove, so
         this old iron wok does fine.
orinoco
response 43 of 55: Mark Unseen   Nov 12 22:54 UTC 2002

Er... might I ask what the oven was doing full of tupperware?
glenda
response 44 of 55: Mark Unseen   Nov 12 23:58 UTC 2002

Unexpected guests before dishes were done, oven easiest place to hide them.
denise
response 45 of 55: Mark Unseen   Oct 20 16:34 UTC 2006

There's been recent talk in the Agora conf. about pressure cooking. I'd like
to learn more about it: how it works, why use it, etc.  Any info would be
apprciated! :-)
keesan
response 46 of 55: Mark Unseen   Oct 20 18:06 UTC 2006

A pressure cooker is faster because the steam in it is at a higher pressure
and therefore gets hotter than 212 degrees.  The pot also heats up faster
because it is well sealed.  Because it keeps cooking after you turn off the
heat, there is much less chance of burning and you don't need to stir. 
Because it is well sealed it loses less heat so saves fuel, and it loses less
steam so keep the kitchen from getting steamed up.  It is cooler in the
summer, and dryer.  It produces less global warming.....
cmcgee
response 47 of 55: Mark Unseen   Oct 21 01:47 UTC 2006

It gives stew the texture and taste of 3 hours of cooking in about 10 minutes.
Great for things you should have put in the crockpot before work, but didn't
get around to.  

It also makes great steamed veges, and cooks dry beans in minutes rather than
the "overnight soak + hours of cooking" timeframe.  
denise
response 48 of 55: Mark Unseen   Oct 21 03:34 UTC 2006

These pressure cookers sound pretty cool!  I'm assuming they come with
instructions on how to cook with them/recipes?  Maybe some day, I'll have to
consider getting one.
i
response 49 of 55: Mark Unseen   Oct 21 03:41 UTC 2006

Do the seals on pressure cookers need to be replaced periodically?  (So
better buy a common type, or at a store that'll be around to sell you
the new seal, or whatever?)
keesan
response 50 of 55: Mark Unseen   Oct 21 14:40 UTC 2006

The gasket for our older Presto is about $6-7 and is available at hardware
stores or from Presto directly (a bit cheaper).  
lar
response 51 of 55: Mark Unseen   Oct 26 15:56 UTC 2006

How about some recipes and directions for Pot roast, roast beef, and 
chicken.
I cook an awesome spaghetti sauce in my crock pot. It takes about 8 
hours for that full rich red flavor. Can it be done in a pressure 
cooker? If it can, how long would it take?
keesan
response 52 of 55: Mark Unseen   Oct 26 16:09 UTC 2006

Things made in pressure cookers are steamed (at high temperatures) so I doubt
you could 'roast' in one.  I think my mother may have browned her pot roast
before pressure cooking it.  Your crock pot, unless it is really tightly
sealed, is probably boiling off a lot of the liquid.  What do you make the
sauce from?  You could substitute tomato paste for tomato puree.
mary
response 53 of 55: Mark Unseen   Oct 26 17:52 UTC 2006

I'd be interested in your spaghetti sauce recipe, Larry.
lar
response 54 of 55: Mark Unseen   Oct 30 22:09 UTC 2006

Sure mary...I'll post it later when I have time
mary
response 55 of 55: Mark Unseen   Oct 30 22:25 UTC 2006

Cool.

 0-24   6-30   31-55        
Response Not Possible: You are Not Logged In
 

- Backtalk version 1.3.30 - Copyright 1996-2006, Jan Wolter and Steve Weiss